Set up your SAVR TPMS
Get your sensors paired, fitted and monitoring in just a few minutes.
SAVR uses separate profiles for each vehicle you monitor. Add your vehicle, pair its sensors, then choose which profiles you want active on your Dashboard.
Watch Installation VideosAdd your vehicle
Go to Profiles in the SAVR app and add the vehicle you want to monitor.
Choose the vehicle type, give it a name and select the number of wheels you want to monitor.
You can add more vehicles at any time.
Towing a caravan or trailer?
Set up your tow vehicle and trailer as separate profiles.
When both profiles are active, SAVR brings all of their wheels together on your Dashboard.
When you're not towing, simply make the trailer profile inactive.
Pair your sensors
There are two simple ways to add SAVR sensors.
Use One-Click Pairing when setting up a complete SAVR 2 Sensor Pack or 4 Sensor Pack.
Select One-Click Pairing in the app and scan the pairing QR code supplied with your SAVR pack.
The sensors in that pack will be added automatically.
Use Scan Pair when adding or replacing an individual sensor.
Select the wheel position in the app, choose Scan Pair, then scan the barcode on the individual sensor.
Complete 2 or 4 Sensor Pack?
Use One-Click Pairing.
Adding or replacing an individual sensor?
Use Scan Pair.
Fit your sensors
Match each sensor to the wheel position shown in the app.
- Remove the existing valve cap from the tyre.
- Screw the supplied anti-theft nut onto the valve stem.
- Screw the SAVR sensor onto the valve stem by hand until snug.
- Hold the sensor firmly and use the supplied tool to tighten the anti-theft nut back against the sensor.
Hand-tight is enough. Do not use a tool to tighten the sensor itself.
You may hear a small amount of air escape while screwing the sensor onto the valve. This is normal.
Check your sensors
Screwing a sensor onto the tyre wakes it up and allows it to start sending tyre pressure data to SAVR.
Once detected, the sensor will show as connected in the app and begin displaying tyre pressure.
Check that each sensor is showing against the correct wheel position.
Not seeing a pressure reading?
Head to Troubleshooting for some quick checks.
Add another vehicle
Create separate SAVR profiles for every vehicle you want to monitor.
For example:
- Car or SUV
- Caravan
- Camper trailer
- Boat trailer
- Motorcycle
- Motorhome or RV
- Truck or multi-axle vehicle
Each profile remembers its own sensors and settings.
Once set up, you don't need to pair those sensors again every time you use that vehicle.
Choose what you want to monitor
SAVR lets you make one or more profiles Active.
All active profiles appear together on your Dashboard.
Driving your car only?
Make your car profile active.
Towing your caravan?
Make both your tow vehicle and caravan profiles active.
SAVR automatically brings their wheels together so you can monitor your complete setup from one Dashboard.
Finished towing?
Make the caravan profile inactive.
It stays saved in SAVR, ready for your next trip.
Your setup is saved
Once you've created a profile and paired its sensors, SAVR remembers it.
You don't need to rebuild your setup every time you travel.
Just choose which profiles are active and you're ready to go.